Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Before Installing the Range
Make sure your range is properly installed and grounded by a qualified installer, according to the installation
instructions. Any adjustment and service should be performed only by qualified gas range installers or service
technicians.
In the Commonwealth of Massachusetts
This product must be installed by a licensed plumber or gas fitter.
When using ball type gas shut-off valves, they must be the T-handle type.
When using a flexible gas connector, it must not exceed 3 feet in length.
Preparing for Installation
Tools Needed
Phillips screwdriver
Open-end or adjustable
wrench
Materials You May Need
Gas line shut-off valve
Pipe joint sealant that resists action of natural and LP gases
Flexible metal appliance connector (
Never use an old connector when installing a new range.
Flare union adapter for connection to gas supply line (
Flare union adapter for connection to pressure regulator on range (
Liquid leak detector or soapy water
Lag bolt or
1
/
" O.D. sleeve anchor (for concrete floors only)
2
Flat-blade screwdriver
Pipe wrench (2)
(one for support)
3
/
" or
1
/
" NPT x
1
/
" I.D.)
4
2
2
3
/
" or
1
/
" NPT x
4
2
INSTALLATION
Pencil and ruler
Level
1
/
" I.D.)
2
1
/
" NPT x
1
/
" I.D.)
2
2
13
Publicidad
Tabla de contenido
Solución de problemas
