Description Of The Appliance; Safety Warnings - DeLonghi BAR41 Instrucciones Para El Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Thank you for choosing this Delonghi coffee machine.
To get the very best out of your new coffee machine
it is advisable to read these instructions before using
the appliance.
This is the only way to ensure
optimum results and maximum safety.

DESCRIPTION OF THE APPLIANCE

The following terms are used throughout the instruction
manual
1 Filter holder for ground coffee
2 1-cup filter
3 2-cup filter
4 Filter holder for pods (if fitted)
5 Steam release knob
6 Coffee tamper
7 Removable drip tray - black area inside for
positioning cups
8 Power supply cable
9 'OK' light
Boiler on function
10
11 Selector knob
12
Espresso function
13 "O" OFF position
14
Cappuccino function (for milk frothing)
15 Coffee measuring spoon
16 Boiler outlet
17 Milk frother
18 Steam nozzle
19 Delivery tube
20 Water tank
21 Lid for water tank

SAFETY WARNINGS

• This machine has been built to "make coffee" and to
"reheat beverages"; please be careful to avoid burns
from the sprays of hot water or steam and avoid any
improper use.
• After unpacking, make sure that the machine is
complete and undamaged. In case of doubt, do not
use the appliance and seek the advice of a qualified
service professional.
• Packaging materials (plastic bags, foam polystyrene,
etc.) should not be left within the reach of children as
this could be a potential source of danger.
• The manufacturer takes no responsibility for damage
derived from improper use.
• Never touch the appliance with wet or damp hands.
INSTALLATION
• Place the coffee maker on flat work surface at a safe
distance from taps and sinks.
• Check that the voltage corresponds to that indicated
on the appliance rating plate. The appliance must
always be connected to a well-earthed socket rated
at 10 A minimum. The manufacturer is not liable for
damage caused by inadeguate earthing of the
appliance.
• In the event of incompatibility between the plug on
the appliance and the socket, have the plug replaced
with another of the right type by a qualified
professional.
If the cable is damaged or requires replacing,
contact a service centre authorised by the
manufacturer only.
• Never install the machine in an environment that can
reach a temperature less than or equal to 0°C (if the
water in it freezes, the coffee maker may be damaged).
• When the machine is in operation, any additional
cable can be stored in the machine by inserting it
back into the cable supply outlet.
USING YOUR MACHINE FOR THE FIRST
TIME
When you are using the machine for the first time, you
should wash all the accessories i.e. filter holder, steam
nozzle etc in warm soapy water and rinse. To ensure
best tasting coffee the internal circuits must also be
flushed through at least five times. To do this follow the
directions below in "How to prepare espresso coffee"
but use only water and not coffee.
HOW TO PREPARE ESPRESSO COFFEE
FILLING THE WATER TANK:
To remove the water tank simply pull upwards (fig 2)
and fill the tank at the sink (fig 3). Do not exceed the
MAX level on the water tank. The tank may also be
filled without removing it, simply by pouring water into
it directly from a jug.
Replace the tank by connecting the valve at the bottom
of the tank with the hole in the base on the machine.
Note: Do not operate the appliance without water in
the tank and always remember to fill the tank when the
water level goes below the MIN level.
7

Publicidad

Tabla de contenido
loading

Tabla de contenido