Installation Of The Co Rf Sensor; General; Rf Sensor - Zehnder RF55 Manual De Instalación

5. Installation of the CO

5.1 General

The CO RF Sensor is always set as the controller.
2
The CO RF Sensor must be paired with the ventilation unit before first use.
2
Within 30 seconds during installation, press the operating button of the CO
confirm a setting.
The combination of a CO
higher on said ventilation unit.
5.2 Installation of the CO
Figure 5.1 ­ Front side of the CO
1. Activate the pairing mode in the ventilation unit:
■ C omfoAir E/ComfoAir PRO/ComfoFan S/CMFe/RPMe/VPMe/ComfoAir
160/180/200/350/450/550 with RF receiver: isolate power to the ventilation unit, wait at
least 5 seconds, then turn the power back on;
■ C omfoAir Q with RF receiver: activate the menu on the ventilation unit via ADVANCED
SETTINGS. > RF SETTINGS > START RF PAIRING;
■ C omfoSense C: on the ComfoSense C, activate the menu via ADVANCED SETTINGS >
RF PAIRING > START.
2
RF Sensor v2.00 with a ComfoAir Q requires firmware R1.8.0 or
2

RF Sensor

2
Sensor
2
RF Sensor
Sensor to
2
Legend
1. Top LED
2. Middle LED
3. Bottom LED
4. Operating button
5. CO LED
2
37 - EN