Overfill Protection Mechanisms; Warranty; Manufacturer's Declaration - CEMO CUBE-Tank Manual Del Usuario

GB
7. Overfill protection
mechanisms
If prevailing law requires the use of overfill
protection mechanisms or limiting value
transmitters for filling stations for the stor-
age of water-hazardous liquids, these can be
equipped as follows:
7.1 CUBE-Tanks for the storage
of heating oil and diesel fuel
The CUBE-Tanks are equipped with an
approved overfill protection mechanism (limit-
ing value transmitter). The installation instruc-
tions are enclosed with the tank papers.
7.2 CUBE-Tanks for the storage of lubri-
cants and pure urea solution 32.5 %
(e.g. AdBlue )
®
The CUBE-Tanks are equipped with an
approved overfill protection mechanism with
warning device. The installation instructions
are enclosed with the tank papers.
7.3 CUBE-Tanks for the storage
of other media
The CUBE-Tanks are equipped with an
approved overfill protection mechanism with
warning device. The installation instructions
are to be complied with.

8. Warranty

We provide a warranty for the resilience
of the material and flawless processing in
accordance with the CEMO warranty condi-
tions. The acceptance of claims under the
warranty applies only on the condition that
the above transport, installation and operat-
ing instructions, and all applicable regula-
tions, are precisely followed.
28

9. Manufacturer's Declaration

Manufacturer's Declaration
We hereby confirm that the
Building product:
CUBE-Tank 1000 l, 1500 l and 2500 l
with general construction inspection
approval Z-40.21-510
of the
Factory:
CEMO GmbH
Kappelweg 2
D - 91625 Schnelldorf
has been successfully tested in accordance
with the requirements of the general construction
inspection approval Z-40.21-510 and of
EN 13341, and that the tank was manufactured
in accordance with the provisions of the general
construction inspection approval Z-40.21-510
and of EN 13341.
Purpose:
Stationary tank for the above-ground storage
of heating oils and diesel fuels in accordance
with EN 13341 as well as for storage media
in accordance with general construction
inspection approval Z-40.21-510.
Schnelldorf, 29 November 2013
______________________
Managing Director