Ordering Filters; Guarantee & Service - Philips FC9166 Manual Del Usuario

English
10
- Philips Anti-Odour s-bag ` paper dustbags are available under type number FC8023.
- Philips Long Performance s-bag ` dustbags for extra-long cleaning performance are available
under type number FC8024.

Ordering filters

- Super Clean Air Filters are available under type number FC8030.
- Super Clean Air HEPA Filters are available under type number FC8031.
- Ultra Clean Air HEPA Filters are available under service number 4322 004 92990.
Environment
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 33).
- Batteries contain substances that may pollute the environment. Do not throw away batteries
with the normal household waste, but dispose of them at an official collection point for
batteries. Always remove the batteries of the remote control before you discard and hand in the
appliance at an official collection point.
guarantee & service
If you need information or if you have a problem, please visit the Philips website at www.philips.com
or contact the Philips Customer Care Centre in your country (you find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your
local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal
Care BV.
troubleshooting
1 The suction power is insufficient.
- The dustbag may be full.
Replace the dustbag.
- The filters may be dirty.
Clean or replace the filters.
- The suction power may be set to a low setting.
Set the suction power to a higher setting.
- The nozzle, tube or hose may be blocked up.
To remove the obstruction, disconnect the blocked-up item and connect it (as far as possible) the
other way around. Switch on the vacuum cleaner to force the air through the blocked-up item in
opposite direction.
 The infrared remote control (specific types only) does not function
- Perhaps the batteries do not make proper contact or have not been inserted in the proper way.
Remove the lid of the battery compartment and push the batteries back into place. Make sure that
the - and + poles point in the right direction.
- The batteries may be empty.
Replace the batteries.