Seav BeWeather Serie Manual De Instrucciones página 16

movement, proceed as follows: check that the extended menu is enabled (SUN, RAIN
and R. HEAT LEDs flash), using the "SEL" key navigate to WIND LED when flashing and
press the "SET" key: the WIND LED lights up permanently and programming is completed.
Repeat the operation to restore the previous configuration.
D) SUN SENSOR ( Rain control movement inversion ) :
The control unit is supplied by the manufacturer with the Rain Control = Upward Move-
ment Control association, that is to say when the rain sensor detects the rain, the control
unit controls the upward movement. If you wish that the control unit controls the down-
ward movement when rain is detected by the rain sensor, proceed as follows: check that
the extended menu is enabled (SUN, RAIN and R. HEAT LEDs flash), using the "SEL" key
navigate to SUN SENSOR LED when flashing and press the "SET" key: the SUN SEN-
SOR LED lights up permanently and programming is completed. Repeat the operation to
restore the previous configuration.
E) RAIN SENSOR (Automatic sensor action Time) :
The control unit is supplied by the manufacturer with the Automatic sensor action Time
of 4 minutes; if you wish to set 10 minutes to reduce the motor movements, proceed as
follows: check that the extended menu is enabled (SUN, RAIN and R. HEAT LEDs flash),
using the "SEL" key navigate to RAIN SENSOR LED when flashing and press the "SET"
key: the RAIN SENSOR LED lights up permanently and programming is completed. Repeat
the operation to restore the previous configuration.
RESET:
To reset the default configuration of the control unit, press the SEL and SET buttons simul-
taneously; all indicator LEDs will switch on and then off again immediately.
Rev. 3.0 05/09/2016
16