Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling; Ordering Replacement Parts - Gardol GAL-E 40 Li OA Manual De Instrucciones Original

batteries.
•
Open the zipper on the catch bag (7) and
shake out the material.
•
Close the zip on the catch bag (7) again.
6.5 Speed control (Fig. 1)
The device is fi tted with an electronic speed con-
troller. To use it, turn the speed controller (Fig. 1/
Item 10) into the required position. Use the device
only with the speed which is actually required and
do not let it run at a speed which is faster than
necessary.
7. Cleaning, maintenance and
ordering of spare parts
Hazard!
Always remove the batteries before starting any
cleaning work.
7.1 Cleaning
•
After shaking out the catch bag, turn it inside
out and thoroughly clean it in order to prevent
mould and unpleasant odours from forming.
•
You can use soap and water to clean out a
heavily soiled catch bag.
•
Rub a bar of dry soap across the zipper teeth
if the zipper becomes difficult to pull.
•
Clean the vacuum/blower tube with a brush
upon evidence of dirt and grime.
•
Dirt and grime can make the switch (blower/
vacuum) more difficult to operate as a result
of the material that swirls up off the ground.
When this occurs, simply flip the switch back
and forth a few times, which should bring it
back to the normal feel.
7.2 Maintenance
•
Should the tool experience problems beyond
those mentioned above, let only an autho-
rised professional or a customer service shop
perform an inspection.
•
There are no other parts inside the equipment
which require maintenance.

7.3 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
Anl_GAL_E_40_Li_OA_SPK7.indb 18 Anl_GAL_E_40_Li_OA_SPK7.indb 18
GB
For our latest prices and information please go to
www.isc-gmbh.info
8. Faults
The equipment does not work:
Check that the battery is charged and whether
the charging unit is working. If the equipment will
not work in spite of the voltage supply being OK,
please send it to the customer service address-
below.

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 18 -
19.04.16 09:36 19.04.16 09:36