Charging The Battery - Hobot 388 Manual Del Usuario

cloth while keeping the upper cleaning cloth dry then clean the glass again.
◎Instructions
1. Setup
(5) Connect the adaptor to DC power cord.
(6) Connect the adaptor to AC power cord.
(7) Plug L-shape connector into DC power jack on HOBOT and screw tight the
L-shape connector.
(8) Plug AC power cord into the socket.

2. Charging the Battery

Make sure the battery is fully charged (green light ON) before use:
(1) Turn off the power switch on HOBOT and then plug it into a power source.
Orange light ON means charging.
(2) Green light ON means the battery is fully charged.
3. Install Cleaning Cloth and Cleaning Ring
Make sure cleaning ring is perfectly covered by the cleaning cloth and attach the
cleaning ring to the cleaning wheel correctly to avoid air leakage.
SmartBot HOBOT – www.hobot.es
- 17 -