Hobot 388 Manual Del Usuario página 25

19.
HOBOT cannot finish cleaning the whole window and stops during the
middle of the work.
Press or
20.
White light flashing with beeping sound when HOBOT stops at the edge
of the glass.
Some glass sealing strips are very flat that HOBOT sometimes can ride/stuck
on them and cause air leakage, please move HOBOT to10 cm or more away
from the window frame and use
21.
HOBOT does not move smoothly, or it moves irregularly.
(5) Cleaning cloth is too dirty, please replace it.
(6) The friction factor difference due to glass stickers, window film, etc. Please
avoid using HOBOT on the glass with special finish.
(7) The screw of the cleaning wheel might have become loose. Just tighten it.
(8) The cleaning ring is broken, please replace it.
22.
After cleaning, swirl marks are left on the glass.
Cleaning cloth is too dirty or too wet, please replace it.
23.
How to avoid leaving swirl marks on the glass which is visible under
strong light?
Use a pair of clean and dry cleaning cloth to wipe dust and dirt off the glass,
then use another pair of clean and dry cleaning cloth, spray small amount of
detergent or rubbing alcohol only on the lower cleaning cloth while keeping the
upper cleaning cloth dry and clean the glass again.
24.
HOBOT does not stop cleaning after completing the task.
Please press
25.
Unable to link to App/HOBOT
(4) Please restart HOBOT and App.
(5) Please turn on Bluetooth function on your smartphone and connect.
(6) Please check the Bluetooth device list on your smartphone and select
"HOBOT".
26.
HOBOT does not spray water.
(4) Check if you have turned on the spraying function.
(5) Clean the of the ultrasonic nozzle with a soft, dry and clean cloth.
(6) Replace the water tank after tried (1) and (2).
If any problems occur and this manual cannot provide the solution you need,
please contact a local retailer or local authorized dealer.
switch to left or right auto cleaning mode.
button to stop HOBOT.
or auto cleaning mode to continue.
SmartBot HOBOT – www.hobot.es
- 23 -