Tube Replacement - Ryobi CFP-180FM Manual De Utilización

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
CFP-180FM
17/06/05
GB
F
D
E
TO INSTALL/REMOVE BATTERY PACK
WARNING
During the change of lamp.
CAUTION
When placing battery pack in your fluorescent
light, be sure raised ribs on battery pack aligns
with groove inside light handle and latches snap
in place properly. Improper assembly of battery
pack can cause damage to internal components.
SWITCH
See Figure 2.
To turn your light on and off, depress switch trigger.
HANGING / STORAGE FEATURE
See Figure 2.
On top of the housing is a hook in which you can use to
hang the light up. This is a good feature for storing light
when not in use and also to keep light out of the reach of
children. To use, simply lift up on hook.

TUBE REPLACEMENT

See Figure 3.
WARNING
During the change of lamp the battery has to be not
contacted with the luminaire. Use only with above
listed fluorescent tube, other type of fluorescent
tubes will result in a risk of electric shock.
13:34
Page 4
I
P
NL
S
DK
N
English
4
FIN
GR
H
CZ
RUS
TO REPLACE FLUORESCENT TUBE
Remove battery pack from fluorescent light.
See "TO INSTALL / REMOVE BATTERY PACK".
Remove screw to release lens cover. Remove lens
cover by pulling forward and lifting from the housing.
To remove old fluorescent tube from spring, gently
grasp the lower edge of the rubber cushion and sides
of bulb. Carefully work tube in a side-to-side motion
while easing tube forward and up until tube is free
from the spring. Do not pull fluorescent tube straight
out from its center, as this increases chance of
breakage. Remove rubber cushion from old
fluorescent tube and place on top of new tube,
rounded edge facing outward.
Insert new fluorescent tube in spring by aligning
prongs on tube with holes in tube socket area. Gently
push down on base of new tube until fully engaged.
Do not force tube into place.
Replace lens cover by sliding lower edge into
housing. Align screw holes at top. With a hand tool,
tighten screw. Do not use drill included in kit to tighten
screw, as drill torque may damage lens cover.
Replace battery pack.
WARNING
Do not attempt to disassemble the battery pack.
Fire or injury may result.
RO
PL
SLO
HR
TR

Publicidad

Tabla de contenido
loading

Tabla de contenido