CARE AND CLEANING
OVEN INTERIOR (Cont.)
Make sure the oven light bulb cover is in place and the
oven light is off. When using the Self Clean Mode in a
cycle at one time. Additionally, no other mode may be
started in the alternate oven cavity while self clean is in
progress.
IMPORTANT: The health of some birds is extremely
sensitive to the fumes given off during the self-cleaning
cycle of any range. Move birds to another well-ventilated
room.
OVEN RACKS
The racks that were provided with your oven (dark
enameled racks, not shiny) may remain in the oven during
the self-cleaning cycle without being damaged.
To manually clean racks, use warm, soapy water. Make
sure not to wash the rack slides on an extension rack.
If racks become more difficult to remove from the oven,
put some vegetable oil on a soft cloth or paper towel and
rub onto the oven rack supports. Do not wipe the oil on an
extension rack slide.
NOTE: Using other cooking oils will cause a discoloring or
a rust like color residue on the racks and cavity sides. To
clean this residue, use a soap and water or a vinegar and
water solution. Rinse with clean water and dry with a soft
cloth.
OVEN HANDLE REPLACEMENT
Some models have custom handles. Please follow the
instructions with the handle for proper installation.
OVEN DOORS
Lift-Off Oven Door
lifting the door.
Do not lift the door by the handle.
To remove the door:
1. Fully open the door.
2. Pull the hinge locks down
toward the door frame,
to the unlocked position.
A tool, such as a small
flat-blade screwdriver, may
be required.
3. Firmly grasp both sides of
the door at the top.
18
Slot
Hinge lock
Pull hinge locks down to unlock
4. Close door to the door removal position. The door
should be open approximately 3" with no obstruction
above the door.
Removal position
5. Lift door up and out until both hinge arms are clear of
the slots.
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. Starting on the left side, with the door at the same
angle as the removal position, seat the indentation of
the hinge arm into the bottom edge of the hinge slot.
The notch in the hinge arm must be fully seated into the
bottom of the slot. Repeat for right side.
Hinge
arm
Hinge
lock
Push hinge locks up to lock
3. Fully open the door. If the door will not fully open, the
indentation is not seated correctly in the bottom edge of
the slot.
4. Push the hinge locks up against the front frame of the
oven cavity, to the locked position.
edge of slot
5. Close the oven door.
Hinge arm
Indentation
49-2000382 Rev.1