Publicidad
Step 11
Step
å
Carefully turn your unit over onto its front edges. Lay the
BACK (H) over your unit.
å
Make equal margins along all four edges of the BACK (H).
Push on opposite corners of your unit if needed to make it
"square".
å
Fasten the BACK (H) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
the LOWER UPRIGHTS (D).
www.sauder.com/services
These holes must line up over
the LOWER UPRIGHTS (D).
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
H
414986
1N
NAIL
(42 used in this step)
Page 15
Publicidad
