Dedicated Micros 2010 Manual De Instalación página 4

2010_2015_completeREV5.qxp
2. Mounting Configuration - 2010
A
E
Enclosure mounting
1. Use bracket arm (E) as a template for marking the position of mounting holes (J) Remove & drill to
pattern required.
2. Attach bracket arm to wall using rawl plugs and screws provided. ( Assuming masonary wall )
3. Attach housing (K) to bracket with 2 off M6 x 12 Trilobular screws provided (G)
4. Release screw (F) to pan housing and screw (H) for tilt. Position as required for camera coverage
& tighten to secure.
5. Feed cables through bracket exiting down (C) or through (A) wall, via conduit, as req'd.
6. An optional Infra red lamp ( type 880/883) may be mounted under the housing as shown (D)
2010/2015 Installation Manual
22/9/09 2:24 pm Page 2
C
D
F G
90º
J
80
H
90º
K
Page. 2