Uline H-7619 Instrucciones De Montaje página 2

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CLAMP MOUNTING
1
Tube
M6 x 20 mm Bolts
4 x 4 Allen
Wrench
Clamp Mounting
Bracket
NOTE: Clamp mount is compatible with desk
thickness of 3/4 – 3⁄".
1.
Attach clamp mounting bracket (5) to bottom of tube (4)
using M6 x 20 mm bolts (C) and 4 x 4 Allen wrench (F).
(See Figure 2)
NOTE: Opening near bottom of tube is for
cable management. Make sure this opening is
aligned with back of clamp mounting bracket.
GROMMET MOUNTING
1
Mounting Plate
Tube
M6 x 20 mm Bolts
NOTE: For grommet mounting, hole in desk
must be 3/8 – 2¾".
NOTE: Grommet mount is compatible with desk
thickness of 1 – 3½".
1. Attach grommet mounting plate (8) to bottom of
tube (4) using M6 x 20 mm bolts (C) and 4 x 4 Allen
wrench (F). (See Figure 3)
NOTE: Opening near bottom of tube is for
cable management. Make sure this opening is
aligned with indent on grommet mounting
plate.
PAGE 2 OF 12
2
Mounting
Holes
2
Grommet
4 x 4 Allen
Wrench
ASSEMBLY
Anti-Slip Foam
M6 x 10 mm
Bolts
Clamp
4 x 4 Allen
Wrench
2. Apply anti-slip foam (6) to rings on clamp (7). Select
the appropriate mounting holes based on thickness
of the desk. Attach clamp (7) to the clamp mounting
bracket (5) using M6 x 10 mm bolts (D) and 4 x 4
Allen wrench (F).
3. Place clamp mounting bracket and clamp over
desk and fully tighten knobs.
Hole
Grommet Bolt
2. Thread grommet bolt (10) through bottom support (9).
Insert bolt into hole of desk and into center hole in
grommet mounting plate (8).
3. Fully tighten grommet bolt (10) using 6 x 6 Allen
wrench.
3
Tighten
3
6 x 6 Allen
Wrench
Tighten
Desk
Figure 2
Figure 3
0521 IH-7619

Publicidad

Tabla de contenido
loading

Tabla de contenido