Uline H-7619 Instrucciones De Montaje página 3

ATTACHING MONITOR ARM
1
1. Place monitor arm (2) over tube (4) and choose
desired height of monitor. (See Figure 4)
2. Flip lever on monitor arm to lock in place. Using
a 3 x 3 Allen wrench, tighten the bolt directly
underneath the lever to secure monitor arm.
ATTACHING MONITOR
1
M4 or M5 x 12 mm Bolt
Flat
Washer
NOTE: Two-person assembly is required for this
step.
NOTE: Depending on size of holes, use either
M4 x 12 mm bolts (A) or M5 x 12 mm bolts (B). If
holes are not deep enough, add flat washers (E)
to bolts to ensure a tight fit.
1. One person should hold the monitor and align
the bolt holes on the back of the monitor with the
mounting plate. The second person should insert
bolts into the top two holes in the mounting plate
and monitor. Loosely tighten both bolts.
NOTE: For 100 x 100 mm VESA hole pattern,
bolts can be inserted into the top holes in back
of monitor and lowered into mounting plate for
easier attachment.
PAGE 3 OF 12
ASSEMBLY CONTINUED
2
3 x 3 Allen
Wrench
2
CAUTION! Make sure lever is tightly locked
before attaching monitor.
3. Attach cable clips (3) to monitor arm.
3
2. While one person continues to hold the monitor, the
second person should insert bolts into the bottom
two holes in the mounting plate and monitor. Then,
fully tighten all four bolts.
NOTE: Repeat steps to attach second monitor.
3
Figure 4
Figure 5
0521 IH-7619