Environmental Protection - Worx WA0220 Manual Original

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended use
This attachment is intended for cutting and trimming
hedges and bushes in domestic use.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Connecting
Remove the existing attachment, and
connect the pole hedge trimmer. Slip
the attachment into the shaft of the
main unit and secure in place with the
locking knob.
Attaching the shoulder strap
It is recommended to always attach the
shoulder strap when using the tool.
IMPORTANT: Never attach the strap
diagonally across your shoulder and
your breast, but rather place it on one
of your shoulders. In this way you can
remove the tool quickly from your body
in case of danger.
Adjusting the head angle
You can adjust the trimming angle (10
positions in total) according to your
needs.
WARNING: Failure to properly
secure the trimmer head may
result in personal injury and/or property
damage.
OPERATION
Removing the blade sheath
Top cutting
WARNING: If any parts are
missing, damaged or broken, do
not operate your hedge trimmer until all
damaged parts have been replaced or
repaired. Failure to do so could result in
serious personal injury.
Side cutting
WARNING: Stop operating the
trimmer before rotating the
handle.
Lubricating the cutting blade
NOTE: It is important to use only the
recommended standard lubricating oil
to avoid damage to the blade.
Pole hedge trimmer attachment
HOW TO USE YOUR HEDGE
TRIMMER
Before cutting an area, inspect it first and remove
any foreign objects that could become thrown or
entangled in the blades.
Always hold the trimmer with both hands and with
the blade away from you before turning it on.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the
blade.
Allow the cutting blades to reach full speed before
FIGURE
cutting. When operating, keep the cutting blades
away from people and objects such as walls, large
stones, trees, vehicles, etc.
If the blade stalls, immediately stop the trimmer.
Release the two Switch Levers before attempting to
clear jammed debris from the cutting blades.
See Fig. A
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick for
the cutting blade.
Top cutting
Use a wide sweeping motion. A slight downward
tilt of the cutting blades in the direction of motion
gives the best cutting results
Side cutting
See Fig. B
When trimming the sides of the hedge, begin at
the bottom and cut upwards, tapering the hedge
inward at the top. This shape will expose more of
the hedge, resulting in a more uniformed growth.
MAINTENANCE
Remove the battery from hedge trimmer
See Fig. C
before carrying out any adjustment, servicing
or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working
See Fig. D
controls free of dust.
FOR BATTERY TOOLS
See Fig.
The ambient temperature range for the use and
E1
storage of tool and battery is 0℃-45℃. (32° F-113° F)
The recommended ambient temperature range for
the charging system during charging is 0℃-40℃.
(32° F-104° F).
See Fig.
E2
ENVIRONMENTAL
PROTECTION
See Fig. F
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authorities or retailer for recycling advice.
11
EN