Sani-tip 122250N Manual Del Usuario página 3

ADAPTER INSTALLATION INSTRUCTIONS
1
2
USER INSTRUCTIONS
1. Remove existing syringe tip.
2. Firmly push Sani-Tip adapter as far as possible into syringe. Adapter will
®
snap audibly when fully engaged and adapter base should be flush with
syringe base. Adapter will fit snugly over syringe opening. Failure to fully
insert adapter will result in leakage and/or loose adapter.
Installation is complete.
1
1. Hold syringe and adapter securely to prevent rotation.
With other hand, loosen thumb nut.
2
2. With thumb nut loosened, insert new Sani-Tip disposable tip and
push into adapter as far as possible. While holding adapter and
pushing in on tip, twist tip 1/2 turn clockwise to create a watertight
seal over internal tapered water spindle.
3 3. Continue to hold the syringe adapter and hand-tighten thumb nut. To
redirect tip, rotate adapter.
TEST PRIOR TO EACH USE: Express water, then express air only.
If air contains moisture, or tip dislodges, refer to Troubleshooting sec-
tion.
4. To replace tip, hold syringe and adapter and loosen thumb nut.
Remove and discard used tip. Repeat steps 2 and 3.
3