AirMan ResQTech Manual Del Usuario página 24

en
Inflator Only
24
TIRE REPAIR INSTRUCTIONS
1. Ensure the selector is in "Repair mode" and the power button is in
the "O" position.
2. Take out the silver hose(sealant hose).
3. Connect silver hose to tire
4. Take out power cord and plug it in the car. But do not turn on car
or kit yet.
5. Remove the speed limit sticker from the kit and put it in a for the
driver visible spot.
6. Start the car.
7. Power on the kit.
8. Inflate tire until required min. pressure has been achieved. If this
is not possible within the time limit. Abort the seal attempt. Call
service.
9. Drive car 5 km at max. 80km/h. Recheck pressure. Inflate if
necessary. If required pressure cannot be achieved, abort sealing
attempt.
10. Drive to tire repair shop/garage.
INFLATE ONLY INSTRUCTIONS
1. Ensure selector in "Air Only Mode" and power button at "O"
2. Take out the black hose(air hose).
3. Connect black hose to tire
4. Take out power cord and plug it in the car.
5. Start the car. Power On.
6. Remove the speed limit sticker from the kit and put it in a for the
driver visible spot.
7. Inflate tire until required min. pressure has been achieved. If this is
not possible within the time limit. Abort. Call service.
Sealant