Manual Override - Belkin AutoSwitch F1U119 Manual Del Usuario

P73074/F1U119/AM/man.qxd
• It does not matter if a PC connects to Port A or Port B, etc... Just make
sure the printer is connected to the end connector (comes in new style,
Port C in old style). See diagram on page 4.

Manual Override

You can use the select button to force the switch to stay on a certain port
indefinitely. Pressing the SELECT button follows this sequence:
AUTO (all 4 LEDs lit up)
If you have the old-model autoswitch, you must set DIP switch #1 to ON for
manual override. Then, you can use the slide switch to select ports.
• If you are using DOS, no other changes are necessary, and no software
needs to be installed.
• The software is not necessary and must NOT be installed. Doing so may
cause your printer to print garbage.
• Avoid using any status monitoring software, status toolbox, or
bi-directional printer drivers. Output-only or Raster drivers are
recommended so that it will not lock up the AutoSwitch.
• Turn off bi-directional
communication on your printer
driver. To do this, click on "Start",
click "Settings", click "Printers",
right-click on your printer, choose
"Properties". Click on the "Details"
tab, then click on the "Spool
Settings" button. The window
shown on the right will appear on
your computer screen:
Make sure "Disable bi-directional
support for this printer" is
selected. Ignore if grayed out.
• Check the end of this manual for
information on disabling
bi-directional communication
on your specific printer.
4/19/00 4:25 PM Page 5
Important Notes
A
5
B C D
En