Concept VP 4200 Manual Del Usuario página 46

E N
If the blue diode starts flashing during operation, it means that the battery is empty and the vacuum cleaner
needs to be charged.
1. Press the button on the handle and turn off the appliance.
2. Disconnect the appliance plug from the wall socket.
3. Connect the charger connector to the accumulator in the vacuum cleaner body.
4. The blue LED will flash, indicating that the appliance is charging normally.
5. As soon as the blue LED stops flashing and starts to shine continuously, the battery is fully charged.
6. Disconnect the charger from the battery and store it in a safe place.
7. The hand vacuum cleaner can be charged individually and when attached to the body of the main
vacuum cleaner.
Attention:
Do not pour water into the charging slot on the body of the appliance to avoid damaging the appliance.
Do not store or recharge the appliance in environment with temperatures below 0 °C or higher than 40 °C.
These temperatures may damage the appliance.
During the charging process, the temperature of the appliance may increase, this is normal.
USE
(for hand vacuum cleaner)
1
Press this button to release
the hand vacuum cleaner
and remove it from the
main body.
4 6
Press the button to turn the appliance on or off.
2
3
Put the slot nozzle into the hand vacuum cleaner.
4
Now you can start vacuuming.
VP 42 00