Clock Alarm Display Mode; Reset System; Default Settings - Oregon Scientific AWS888N Instrucciones De Funcionamiento

CLOCK ALARM DISPLAY MODE

This is a display mode that presents the time, date,
and alarm one of the following ways:
Digital Analog
*In Classic display mode, the hourly chime is animated
with a cuckoo bird and cuckoo sound.
NOTE You can set which clock is displayed from the
CLOCK SETTNG mode. Access the FORMAT option
to toggle between Digital, Analog and Classic views.

RESET SYSTEM

The RESET buttons are located on the back of the
main unit and in the battery compartment for the remote
unit. Press these buttons whenever you change the
batteries, or whenever performance is not behaving as
expected (e.g., unable to establish radio frequency link
with remote unit or automatic clock, etc.).
NOTE
After resetting the system all system
information will be erased and returned to factory
defaults. The main unit will also check battery
condition.

DEFAULT SETTINGS

Date
Time
Clock display
Daily/weekly alarm
Classic*
Sleep Mode
Silence Mode
Weather
Pressure display
Altitude
Thermo-hygro display
Indoor temperature trend
Indoor humidity trend
Sensor search
Receive RF clock
Press RESET to restore all settings to factory defaults.
17
1/1/2003
00:00:00 (24 hour format)
or 12:00:00 am (12 hour
format)
Time-second display mode
Alarm disabled
Sleep start at 12:00 a.m.
and sleep end at 6:00 a.m.
& function disabled
Off
Partly cloudy
Current pressure
0m
Current indoor
Steady
Steady
Enabled
Enabled