fcc sTaTEMEnT and warnInG
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
•
Reorient the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be specified in the instruction manual.
MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT UNDER FCC RULES.
The normal function of the product may be disturbed by strong electromagnetic interference. If so, simply reset the product to resume normal operation by
following the instruction manual. In case the function could not resume, please use the product in another location.
CAUTION
rIsK Of ElEcTrIc
sHOcK — dO nOT OpEn
THE LIGHTNING
THE EXCLAMATION
FLASH AND
CAUTION: TO REDUCE
POINT WITHIN
ARROWHEAD
THE RISK OF SHOCK, DO
THE TRIANGLE IS
WITHIN THE
NOT REMOVE COVER. NO
A WARNING SIGN
TRIANGLE IS A
USER-SERVICEABLE PARTS
ALERTING YOU
WARNING SIGN
TO IMPORTANT
INSIDE. REFER SERVICING
ALERTING YOU
INSTRUCTIONS
TO QUALIFIED SERVICE
TO DANGEROUS
ACCOMPANYING
PERSONNEL
VOLTAGE INSIDE
.
THE PRODUCT.
THE PRODUCT.
0155CSK - JBL On Time 200P_v4 .indd 3
warnInG: TO PREVENT FIRE OR
ELECTRICAL SHOCK HAZARD, DO NOT EXPOSE
THIS PRODUCT TO RAIN OR MOISTURE.
warnInG: THE APPARATUS SHOULD
NOT BE EXPOSED TO DRIPPING OR SPLASHING
AND NO OBJECTS FILLED WITH LIQUID, SUCH AS
VASES, SHOULD BE PLACED ON THE APPARATUS.
IMpOrTanT:
THE APPROPRIATE ADAPTER MUST BE INSTALLED BEFORE
INSERTING YOUR iPod/iPhone INTO THE JBL
®
PRODUCT.
MAKE SURE THAT THE CONNECTOR FOR THE iPod/iPhone IS
PROPERLY ALIGNED WITH THE JBL PRODUCT'S CONNECTOR
WHEN INSTALLING YOUR iPod/iPhone. FAILURE TO DO SO
MAY CAUSE PERMANENT DAMAGE TO THE CONNECTOR FOR
THE iPod/iPhone, RENDERING THE iPod/iPhone INOPERABLE.
Declaration of Conformity
We, Harman Consumer, Consumer Division
8500 Balboa Blvd.
Northridge, CA 91329
USA
As the manufacturer and through our representative within the EU
Harman Consumer, Consumer Division
2, route de Tours
72500 Chateau du Loir
France
Do declare under our sole responsibility that the product listed
below conforms to the requirements of the Directive(s) and
Standards listed here in.
Type of Equipment: iPod docking clock radio
Model(s): On Time 200P
Directives to which Conformity is declared:
2004/108/EC – EMC Directive, as amended.
2006/95/EC – Low Voltage Directive, as amended
2004/32/EC – Energy Using Products Directive, as amended
Harmonized Standards Applied to show Conformity:
EN 55013:2001+A1:2003+A2:2006
EN 55020:2007
EN 61000-3-2:2006
EN 61000-3-3:1995+A1:2001+A2:2005
EN 60065:2002+A11:2008
EN 60825-1:2007
Richard Metcalf
Product Manager
Château du Loir, France 08/09
www.jbl.cOM
3
04/09/09 12:39:36