Alarm Setting - JBL On TIME 200p Manual Del Usuario

8 jbl On TIME 200
0155CSK - JBL On Time 200P_v4 .indd 8
cOnTrOls (cOnT.)

Alarm Setting

†
1. Press Menu/Up Level at any screen to display Top Menu (may require repeated presses,
depending on which menu state the unit was previously in).
2. Use Up/Down arrows to highlight Alarm. Press Enter to confirm; or press Alarm to go directly to the Alarm menu.
3. Use Up/Down arrows to select an Alarm slot to edit. Press Enter to confirm. Hour field becomes highlighted.
4. Use Up/Down arrows to set Hour. Press Enter to confirm. Minute field becomes highlighted.
5. Use Up/Down arrows to set Minutes. Press Enter to confirm. AM/PM field becomes highlighted.
6. Use Up/Down arrows to set AM/PM. Press Enter to confirm.
7. Use Up/Down arrows to set Day of Week, Weekdays, Weekends, Everyday or One-Time. Press Enter to confirm.
8. Use Up/Down arrows to set Alarm source. Press Enter to confirm. Alarm is set!
Note: During alarm-setting, if there is no user input for 2 seconds, display will return to the Now Playing screen. Press any one of the
Enter, Up/Down arrows, or Menu/Up Level to return to setting selection.
Use this same procedure to modify a previously set Alarm.
†
To Enable/Disable a Set Alarm
1. Press Menu/Up Level at any screen to display the Top Menu (may require repeated presses,
depending on which menu state the unit was previously in).
2. Use Up/Down arrows to highlight Alarm. Press Enter to confirm;
or press Alarm to go directly to the Alarm menu.
3. Use Up/Down arrows to highlight Alarm. Press Alarm to enable/disable the alarm.
An icon will be displayed on the left when the alarm is enabled, and the alarm will sound at the set time.
Waking to the iPod/iPhone
1. Use the steps under Alarm Setting and choose "iPod" as the source.
2. On your iPod/iPhone, choose the song you would like to awaken to and press Play.
3. Put your iPod/iPhone to sleep by holding down the Play/Pause button (older iPod models may vary).
4. The JBL On Time 200P system can be put to sleep by pressing the Power button.
Note: If you choose the last song on your iPod/iPhone, please place the iPod/iPhone in repeat mode, which will ensure that the iPod/iPhone will continue playing past
the last song.
UsEr GUIdE
p
Power
Alarm
Source
Preset
Select Up
Menu/Up Level
Enter
Select Down
04/09/09 12:39:41