Sanus Systems VMCC1 Instrucciones De Montaje Internacional página 7

Assembly Instructions for the VMDD and VMDD26 flat panel wall mounts.
Step 7: Remove mount from Wall Plate and remove lower Cross Tube from the mount assembly.
Remove the mount from the wall plate. Loosen the Allen Bolts in the lower four Vise Assemblies and remove the lower Cross Tube from
the mount assembly. See Diagram 7 below.
Diagram 7
vise
assemblies
cross tube
Step 8: Add Axis Brackets
If the threaded inserts on your speaker are spaced between 1.5 inches and 5.7 inches, you do NOT need to use the
Support Bar (g) for the installation.
Position the Axis Bracket (d) so it fits the Axis Assembly on the mount. Insert 1/4 - 20 x 5/8 Bolt (k) through the outer side of the Axis
Bracket, Axis Assembly, and into a 1/4 - 20 Nut (m). Insert a 1/4 - 20 x 1.5 Bolt (n) through the inner side of the Axis Bracket, a Spacer
(l), the inner edge of the adjacent Axis Bracket. Thread it into a 1/4 20 Nut. Slide the Support Bar through the slots in each Axis Bracket
until centered with the wall mount. See Diagram 8 below.
Detailed View
Diagram 8
k m
m
l
axis assembly axis assembly
n
d
d
VMCC1ins_010606_ML.indd 7 1/16/06 10:31:59 AM