Anker NEBULA Solar Manual Del Usuario página 15

EN
[Keystone Correction]
[Zoom]
[Auto Focus Correction]
[HDR]
[Projector Mode]
3. Audio
Audio format can be changed via the Audio Settings.
① On the home page, select
Auto change digital audio format
4. HDMI
Choose HDMI as the input source. You can also change CEC settings.
① On the home page, select
CEC Settings
HDMI
HDMI 2.0
13
Enable / disable auto keystone correction.
[70-100%]
Press Enter to run auto focus correction.
Set to On by default .
Enable / disable HDR effect.
[Auto]: Automatically detects whether the projector is inverted.
Automatically switch between these options.
[Front Projection]: The projector is located in front of the
projection surface.
[Rear Projection]: The projector is located behind the
projection surface.
[Inverted Front Projection]: The projector is hanging
from the ceiling in an upside down position. The image is
rotated by 180 degrees.
[Inverted Rear Projection]: The projector is hanging
from the ceiling in an upside down position behind the
projection surface. The image is rotated by 180 degrees
and horizontally mirrored.
> [Audio Settings] and and press
Enable or disable automatic digital audio format
change between PCM and RAW .
> [HDMI] and and press
Press Enter to change CEC settings.
When an HDMI device is connected, the projector
will start playing content on the HDMI devices.
On / Off
.
.