Unit Assembly - Uline H-2450 Instrucciones De Montaje

POST ASSEMBLY
1. Connect tall post tops and tall post bottoms to each
other by screwing them together. (See Figure 1)
NOTE: Tall post tops have a black plastic cap in
the top of the post.
Figure 1
TO INSTALL SELF-LEVELERS
NOTE: If installing casters, do not install self-
levelers.
1. Make sure post is positioned as shown. (See Figure 2)
2. Insert self-leveler into open end of post. Tap on
ground to slide self-leveler into post.
Figure 2
3. Repeat step 2 for all other posts.
TO INSTALL OPTIONAL CASTERS
1. Make sure post is positioned as shown. (See Figure 3)
2. Engage the wheel brakes to keep casters from
rolling during assembly. Use a rubber mallet to tap
caster stem into posts. (See Figure 3)
Figure 3

UNIT ASSEMBLY

1. Snap shelf supports into the very bottom groove of
two short and two tall posts. (See Figure 4)
2. Slide posts through underside of square frame until it
slides firmly over the supports. (See Figure 5)
Figure 4
PAGE 2 OF 12
Figure 5
ASSEMBLY
3. Take the other four tall posts, snap shelf supports into
the very bottom groove on all four posts. Slide posts
through underside of square frame until it slides
firmly over the supports. (See Figure 6)
Figure 6
4. Position each of the four posts as shown and snap
four sets of shelf supports into the groove directly
above the square frames of the inner four posts.
(See Figure 7)
Figure 7
5. Slide a square shelf onto the inner four posts until it
slides firmly over the supports. (See Figure 8)
Figure 8
0721 IH-2450