NIXON The Blaster Pro Manual Del Usuario página 6

Multi pair it
Hold both track skip buttons on both
speakers to engage + 3 SEC
Press and hold both track skip buttons at the same time on 2 Blaster Pros for 3
seconds then release to enter into Multi-Pairing mode.
This will activate a sound prompt explaining that 2 devices are entering into
Multi Pair Mode.
After 5 seconds a sound prompt will notify you that 2 Blaster Pros are Multi Paired.
Press and hold the Multi Button for 2 seconds then release to enter Bluetooth
Mode. The speaker will sound a tone and the Bluetooth
Now locate the Bluetooth® settings on your music device, enable Bluetooth®, and
then select "NIXON Blaster Pro" from the list of local Bluetooth
When Bluetooth ® pairing is successful, the Bluetooth
illuminate solid.
NOTE: If your music device supports automatic Bluetooth
Blaster Pro may ask your music device to connect. Simply confirm by selecting "OK"
on your music device.
If your music device does not support Bluetooth
Audio Cable to play music directly to The Blaster Pro.
NOTE: When using the AUX input of The Blaster Pro, the Bluetooth
is disconnected, and the remote control buttons and internal microphone will not
function.
+
® LED will flash repeatedly.
® devices.
It is important to note that your Bluetooth
enabled device is connected to 1 Blaster Pro at
a time and the second Blaster Pro is connected
by a signal sent out by the main Blaster Pro.
You will need repeat these instructions to
connect to authentic Blaster Pro through "multi
– pairing" mode.
® LED will stop flashing and
® connection requests, The
® connections, use the included AUX
® audio signal
Crank it up
Volume
Down
Use the Volume Up and Volume Down buttons to set the playback level of The Blaster
Pro.
If the sound is distorted, decrease the volume setting on your music device first, then
set the volume level of The Blaster Pro. A low battery can also cause the sound to
become distorted, so it is important to keep a healthy charge.
NOTE: Because the volume control buttons of The Blaster Pro do not control the
volume output of your music device, you must properly adjust the volume settings of
each device independently.
Switch it up
® Pairing
®
You can control many functions of your music device directly from The Blaster Pro
when connected via Bluetooth
NOTE: When you first power ON The Blaster Pro and reconnect to your music device,
simply pressing the Multi Button will begin music playback from where you last
stopped.
Volume
Up
PLAY/PAUSE
NEXT TRACK
PREVIOUS TRACK
FAST-FORWARD HOLD
REWIND HOLD
®
.