NIXON The Blaster Pro Manual Del Usuario página 7

Talk it up
You can also use The Blaster Pro as a "speakerphone" when connected via Bluetooth
Incoming and outgoing calls will automatically pause music playback, then resume
when the call is ended.
Answer Incoming Call
Reject Incoming Call
End Current Call
Redial Last Number
Press both volume buttons at the same time to MUTE the microphone during a call.
The two LEDs will alternate flashing to let you know MUTE is enabled. Press both
buttons again to UNMUTE the microphone.
NOTE: The internal microphone is designed to pick up your voice from a reasonably
short distance. It is not necessary hold The Blaster Pro close to your mouth.
® .
(pause music)
Hold 2 Seconds
(resume music)
+
Charge it up
Connect the USB Charging Cable between The Blaster Pro and a USB port on a
notebook or desktop computer, or use the included USB to AC adapter. While
charging, the Power LED will flash in a repeating pattern to indicate the current
battery status as shown in the following Battery Check section.
50 cm USB Cable, Micro USB
50 cm USB Cable, Micro USB
When charging is complete, the Power LED will stop flashing and illuminate solid if
The Blaster Pro is powered ON, or turn off completely if The Blaster Pro is powered
OFF.
NOTE: A full charge will take about 6 hours when connected the USB port of a
computer and only 3 hours when connected to a power source using the included
USB to AC adapter.
(Included)
(Included)