Important Notices - LaserLiner LaserRangeMaster Pocket Manual Del Usuario

b
f
e
a
1.
8.
7.
6.
5.

Important notices:

• Caution: Do not look directly into the beam. Lasers must be kept out
of reach of children. Never intentionally aim the device at people.
• The laser points to the location that will be measured. No objects may
get into the laser's line of measurement.
• The device compensates the measurement for different room
temperatures. Therefore allow the device a brief adaptation period
when changing locations with large temperature differences.
• The device is only conditionally useable in outdoor areas and cannot be
used in strong sunlight.
• The device cannot be used in strong sunlight.
• The measurement results of outdoor measurements may be influenced
or falsified by rain, fog and snow.
• In unfavourable conditions, e.g. with poorly reflecting surfaces, the
maximum deviation may be greater than 3 mm.
• Carpeting, upholstery or curtains will not reflect the laser optimally.
Measure to flat surfaces.
• Measurements made through glass (window panes) can falsify mea-
surement results.
• An energy-saving function switches the device off automatically.
• Clean with a soft cloth. Water may not be allowed to penetrate the
housing.
Continuous measurement:
device on and press the READ button (1) for about 4 seconds. The device
now measures continuously and displays the smallest value (min), the
largest value (max) and the current value. Another brief press of the READ
button (1) will interrupt continuous measurement or restart it again.
LaserRangeMaster Pocket
DISPLAY:
a
Measurement point (reference)
rear / tripod / front / pin
d
b
Display length, area / volume /
Pythagoras 1 / Pythagoras 2
c Measurement values /
c
Measurement results
Unit m/mm/ft/inch
d Intermediate values / min/max values
e Battery symbol
f
min / max measurement
KEYPAD:
1. Measure / Continuous measurement
2. min / max continuous measurement
2.
3. length, area, volume, Pythagoras
4.
Unit of measure m/mm/ft/inch
3.
5. ON/OFF
6. Measurement point (reference)
4.
rear / tripod / front / pin
7. addition / subtraction of
lengths, areas, volumes
8. delete last measurement values
Use the ON/OFF button (5) to turn the
09
GB