Safety Instructions - LaserLiner AC-Tracer Manual De Instrucciones

Read the operating instructions and the enclosed brochure „Guarantee and addi-
!
tional notices" completely. Follow the instructions they contain. Safely keep these
documents for future reference.
Function / Application
Cable tracer set with transmitter and receiver
– Fast tracing of coherent electrical circuits.
– Location of lines in coherent, live electrical circuits.
– Detection of fuse circuits in live installations.
– Transmitter power supply directly from power cable to be tested = measurement under
operating conditions.
– Socket adapter for direct and fast testing in building installations.
– E27 lamp adapter for direct and fast testing in lamp circuits.

Safety instructions

– The device must only be used in accordance with its intended purpose and within the scope
of the speci cations.
– Use only original test adapters.
– Only the original measuring leads may be used. Their voltage, category and ampere
rated powers must match those of the measuring device.
– Isolate the device from all current sources before opening the battery compartment cover.
– If possible, do not work alone.
– If you have to take hold of the measuring spikes, do so by the grip sections only. Do not
touch the measuring contacts whilst the measurement is being taken.
– Only connect the completely prepared device (transmitter with test leads plugged in) to a
power source. First disconnect the electrical circuit from the power supply and only switch
on again after wiring work has been completed. Lock the master switch to prevent it being
inadvertently switched on.
– If the device comes into contact with moisture or other conductive residue, work must
not be carried out under voltage. At and above voltages of 25 V AC/60 V DC, the presence
of moisture creates the risk of life-threatening electric shocks. Clean and dry the device
before use. When using the device outdoors, make sure that the weather conditions are
appropriate and/or that suitable protection measures are taken.
– If you are working with voltages higher than 25 V AC/60 V DC, exercise extreme caution.
Touching the electrical conductors at such voltages poses a risk of life-threatening electric
shocks.
– Do not use the device in environments in which there are con-ductive particles or where
the occurrence of moisture (in the form of condensation, for example) can create transient
conductivity.
8
GB