AERMEC SSM Manual De Instrucciones página 4

SSM
probe for Domestic Hot Water and mixer valve
PGD1 display (zone 1)
Inputs/Outputs
Analogue inputs
B7= System delivery
temp.
B8= Delivery
circ.
PGD1 display (zone 2/3)
Inputs/Outputs
Analogue inputs
pCOe1 expansion
B1= Delivery on mix
circ. 2
pCOe2 expansion
B1= Delivery on mix
circ. 3
4
SSM _11.02_4804280_01
025.4 o C
on mix 1
022.3 o C
020.4 C
o
020.4 C
o
WARNING: The SSM probes are accessories to be connected to the electronic
board, therefore all precautions for the electronic boards must be implemented.
DESCRIPTION
SSM is composed of two probes with six meter long cables, of which for the mixer
valve. SSM is to be requested together with the VMFCRP zone accessory (for
zones 2 and 3).
THE KIT CONTAINS THE FOLLOWING COMPONENTS:
• 1 SSM probe for the mixer valve
• 1 metal tie Ø min. 24mm / Ø max. 36mm
• 1 tube of conductive paste to be applied to the probe (COMPULSORY)
CABLE TYPE:
• Bipolar double sheath, AWG22 with electrical resistance ≤ 73.9 Ω / km.
MAX CABLE LENGTH:
• Length 10m max connection.
ASSEMBLY
To install the accessory probe must be inserted on the control board on the unit or
direct on the VMFCRP (see diagrams on next page), and the bulb on the delivery
pipe downstream of the mixer valve.
ERRORS
The following error code are displayed on the PGD1 user interface if the probes
are not installed correctly:
ALARM CODE DESCRIPTION
ALL008 PROBE B3 BROKEN OR DISCONNECTED MIXER VALVE
NOTE:
Before connecting the metal clamp remember to apply the conductive paste to
the probe included with the kit SSM.
EN
COMPONENT