Troubleshooting - Indesit DFG 26B10 Manual De Operación

Troubleshooting

Whenever the appliance fails to work, check for a solution from the following list before calling for Assistance.
EN
Problem:
The dishwasher cannot be started or
controlled.
The door won't close.
No water drains from the
dishwasher.
The dishwasher is too noisy.
The dishes and glasses are
covered in a white film or
limescale deposits.
The dishes and glasses are
streaked or have a bluish
tinge.
The crockery has not been
dried properly.
The crockery is not clean.
The dishwasher does not take
any water in - Tap shut-off
alarm.
(The Drying and End indicator lights
flash quickly.)
*
Only available in selected models.
14
Possible causes / solutions:
• Switch off the appliance by pressing the ON/OFF button. Switch it back on
after approximately one minute and reset the program.
• The appliance has not been plugged in properly.
• The dishwasher door has not been shut properly.
• The lock was released. Strongly push the door until a "clacking" noise is
heard.
• The dishwasher cycle has not finished yet.
• The water drain hose is bent (see Installation).
• The drain duct is blocked.
• The filter is clogged up with food residues.
• The dishes are rattling against each other or against the sprayer arms.
• An excessive amount of foam has been produced: the detergent has not been
measured out correctly or it is not suitable for use in dishwashers (see Start-
up and use).
• The level of refined salt is low or the dosage setting is not suited to the
hardness of the water (see Rinse aid and salt).
• The lid on the salt dispenser was not closed properly.
• The rinse aid has been used up or the dosage is too low.
• The rinse aid dosage is too high.
• A wash cycle without a drying cycle has been selected.
• The rinse aid has been used up or the dosage is too low (see Rinse aid and
salt).
• The rinse aid setting is not suitable.
• The crockery is made from non-stick material or plastic.
• The racks are overloaded (see Loading the racks.)
• The crockery has not been arranged properly.
• The sprayer arms cannot move freely.
• The wash cycle is too gentle (see Wash cycles).
• An excessive amount of foam has been produced: the detergent has not been
measured out correctly or it is not suitable for use in dishwashers (see Start-
up and use).
• The lid on the rinse aid compartment was not shut correctly.
• The filter is dirty or blocked (see Care and maintenance).
• The refined salt level is low (see Rinse aid and salt).
• There is no water in the mains supply.
• The water inlet hose is bent (see Installation).
• Turn on the tap and the appliance will start after a few minutes.
• The appliance stopped because no action was taken when the beep
*
*
Only available on selected models
sounded . (
Switch off the machine using the ON/OFF button, turn on the tap and switch
the machine back on after 20 seconds by pressing the same button. Reset the
appliance and restart the wash cycle.
.)