Technical Specifications; Using The Led Light - Stanley SXAE00135 Instrucciones De Uso

2.2. Technical specifications

Reference
Model
Capacity
Output Voltage
Start Amps
Peak Amps
Internal Battery type
USB output
2.3. Charging the booster
2.3.1. Checking the level of the internal battery
Slide the ON/OFF switch to the ON position. The LCD display will show the battery's percentage of
charge. A fully charged internal battery will read 100%. Charge the internal battery if the display shows
it is under 85%.
2.3.2. Charging the internal battery
Charge the unit as soon as possible after use. Never completely discharge the battery.
Use a 2A USB charger (not included), or a 2A USB charging port to quickly recharge the booster.
Using a charger with less than 2A will increase charge time.
1. Plug the Micro USB end of the charging cable into the input port. Next, plug the USB end
of the charging cable into a charger's USB port
2. Plug your charger into a live AC or DC power outlet.
3. The LCD display will light; the digit begins to flash and show "IN", indicating that charging
has begun.
4. The booster will be fully charged in about 6 hours (with 5V DC, 2A charging input). When
the unit is fully charged, the display will show "100%".
5. When the battery is fully charged, disconnect your charger from the outlet, and then remove
the charging cable from the charger and the unit. Slide the ON/OFF switch to the OFF position,
if you are not using the unit immediately.

2.4. Using the LED light

1. Slide the ON/OFF switch to the ON position.
2. Hold down the power button for 3 seconds.
3. Once the LED light is on, press and release the power button to cycle through the following
modes:
Steady glow

Flash for an SOS signal

Flash in strobe mode

4. When finished using the LED light, press and hold the power button until the light turns off.
5. Slide the ON/OFF switch to the OFF position.
6. Recharge the unit as soon as possible after each use.
3. Instructions manual
3.1. To start a vehicle
SXAE00135
Lithium booster 12V-1000A
11.200mAh / 41.44Wh
14,8V (For 12V vehicle)
500A
1000A
Lithium ion (Pouch cell)
5V DC - 2,4A / QC 3.0
6