Stanley SXAE00135 Instrucciones De Uso página 7

IMPORTANT:
 Do not use the booster while charging its internal battery.
 Using the booster without a battery installed in the vehicle will damage the vehicle's electrical
system.
 Only jump start a 12V lead-acid battery system vehicle.
NOTE: The internal battery must have a charge if at least 40% to jump start a vehicle.
Turn OFF ignition and all electrical devices (heating, lighting...) before using the booster.
Lay the DC cables away from any fan blades, belts, pulleys and other moving parts.
1. Connection to the booster - Stand-by mode
Plug the battery clamp smart cable into the booster's output socket. The green LED is flashing
on the smart cable, which means that the booster is in "Jump Start Stand-by mode".
2. Connection to the battery
Check first if the negative terminal is connected/grounded to the chassis. If not, contact your
reseller.
Connect the red clamp (+) to the positive terminal (+) of the battery, then connect the black
clamp (-) to the earth/chassis of the vehicle (a heavy gauge metal part of the frame or engine
block. Do not connect to the carburetor or fuel lines).
3. Jump Start mode
The green LED on the smart cable turn into solid green, which means that the booster is in
"Ready to Jump Start mode".
NOTE: Once the LED light is green (solid), you will have 120 seconds to jump start the vehicle.
Otherwise, you need to restart the booster procedure back to step 1.
NOTE: If the vehicle battery is extremely discharged, the initial current draw from the booster
may activate short circuit protection in the smart cable. When the condition is corrected, the
smart cable will automatically reset.
4. Start the engine
Crank the engine for maximum 3 seconds and wait at least 1 minute before a second attempt.
5. Disconnect the output lead
After the engine starts, unplug the battery clamps from the booster socket.
6. Disconnection
Disconnect first the black clamp (-) and then the red clamp (+).
3.2. Starting attempt
When using the booster to start an engine, do not crank for more than 3 seconds, and
wait at least 1 minute before a second attempt.
If the car does not crank a second time, check the smart cable to see if the green LED is lit (solid). If
you hear beeping or an LED is flashing, refer to Troubleshooting.
If no activity is detected, the smart cable will automatically shut off after 120 seconds, and the red and
green LEDs will be solid. Disconnect the booster from the vehicle battery, then restart from Jump
Start Step 1.
NOTE: Cold weather may affect the performance of the booster's lithium battery. If you hear only a
click and the engine does not turn over, try the following:
7