Polk Audio SurroundBar One-Step Manual Del Usuario página 8

GET READY FOR GREAT SOUND
A few easy steps, and you're ready to start enjoying your
SurroundBar ® One-Step ™ .
1 Connect the SurroundBar One-Step power supply to
the SurroundBar One-Step and plug the other end into
an AC outlet.
2 Plug the subwoofer power cord into an AC outlet
and into the back of the Wireless Subwoofer.
3 Turn on the power switches on both the
SurroundBar One-Step and the Wireless Subwoofer.
4 Turn on the other components in your system
and tune to a familiar channel.
You should hear sound from the SurroundBar One-Step.
If you don't, turn up the volume on the SurroundBar One-Step
using its volume control buttons.
If your SurroundBar One-Step is connected to your TV, try
adjusting the volume using the TV remote control. If the volume
level of your SurroundBar One-Step changes, it means it is
connected to a "variable" output. The mute control on your
remote control should also work. In this case you do not have
to program your SurroundBar One-Step to respond to your
remote control. If the volume level does not change, refer
to page 9 "HOW TO SET UP A REMOTE CONTROL FOR
YOUR SurroundBar One-Step."
If your SurroundBar One-Step is connected to your TV, there's a
very good chance your TV speakers are also playing. It's impossi-
ble to give specific instructions on how to turn off the speakers
for every TV, but here's a way to do it that covers many of the
TVs out there.
1 On your TV remote control, find a "menu" or "setup" button.
2 Press this button. You should see an on-screen menu.
3 Next, look for an option to control audio functions
and select it. The setting to turn off your TV's internal
speakers should be here.
8 Polk Audio Customer Service 800-377-7655 (Outside USA & Canada: 410-358-3600)
HOW TO OPTIMIZE THE SOUND
WHEN TV SPEAKERS ARE ON
If you can't turn off your TV internal speakers, don't worry.
Your SurroundBar One-Step will make your TV sound much better.
To enjoy the best performance from your SurroundBar One-Step,
you'll want it to play louder than your TV. Use the following
steps to adjust the volume balance between your TV and
the SurroundBar One-Step:
1 If necessary, program your SurroundBar One-Step to respond
to the volume up and down control commands of your TV
remote. (See "HOW TO SETUP A REMOTE CONTROL
FOR YOUR SurroundBar One-Step." on page 9.)
2 Turn your TV volume all the way down using the control
buttons on your TV.
3 Then, using the volume control buttons on your
SurroundBar One-Step, set the volume to a normal
listening level.
After you make these adjustments, your SurroundBar One-Step
should always be louder than your TV speakers. Then use the
TV remote control to adjust the volume as you normally do.
NOTE: You may need to adjust the GAIN LEVEL to "2" or
"3" to compensate for the low TV volume setting (see page
9 for details).