Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Partslist
1. Blade
2. Screw
3. Nut
4. Set screw
5. Rear guard
6. Front guard
7. Oscillation knob
Assembly
If your fan comes ready assembled ignore this part.
1.
Remove the parts from the packing. Separate the front and rear guard if they are
connected.
2.
Set the rear grille in the proper position with handle up.
3.
Screw on nut tightly to attach grille.
4.
Loosen the set screw on the blade, slide the blade onto the shaft of the motor,
tighten the set screw onto the flat of the shaft to secure the blade. Ensure that
the blade does not touch the guards.
5.
Assemble the front guard to the rear guard. Tighten the connecting screw and
nut, secure the retaining clips.
6.
Remove the set screw on the pole , offer up and align the base with the hole on
the pole insert the base set screw and tighten.
Operation
The Desk Fan features three speeds, a swivel action head giving a smooth oscillation action along
with low noise levels, low electrical usage, reliability with safety, while still providing efficient air
flow. The on/off switch is incorporated in the rotary switch in the motor housing.
0- The Fan is switched Off
1- The Fan operates at the lowest speed
2- The Fan operates at the medium speed
3- The Fan operates at the highest speed
•
The fan can operate in oscillation or static mode.
•
To make the fan head oscillate, push down the oscillation Knob.
•
To stop the fan head from oscillating, pull-up the oscillation Knob.
•
The head of the fan can be adjusted up or down, to do this loosen the adjusting knob, adjust
the fan to the desired angle, to secure tighten the adjusting knob.
8. Power knob
9. Motor
10. Power cord
11. Adjusting knob
12. Base
13. Base set screw
Publicidad
Tabla de contenido
