Publicidad
Idiomas disponibles
Idiomas disponibles
16
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select "RADIO FREQUENCY HUB MODULE (RFHM)"
• Turn the ignition to the off/lock position. The ignition must be left off throughout this procedure on
vehicles equipped with the RFHub.
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "PROGRAM IGNITION FOBIKs"
• Select "CONTINUE"
• Note OnScreen instructions and select the "FINISH" button
• Cycle ignition key after the successful routine completion.
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
3. Turn the ignition ON.
• Select "RADIO FREQUENCY HUB MODULE(RFHm)"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "RFHUB REPLACE"
• Select the "Start Misc Function" button
• Select "NEXT"
• Enter the PIN when prompted.
• Select "NEXT"
• Verify that the PIN number is correct
• Once verified select "NEXT"
• Select "NEXT"
• Note OnScreen instructions and select the "CLOSE" button
• Cycle ignition key after the successful routine completion
9/19/13
Publicidad
