Bosch ROTAK 34 LI Manual Original página 32

32 | English
Problem
Machine leaves ragged finish
and/or
Motor labours
Area of cut (battery duration)
not large enough
Cutting blade not rotating while
machine switched on
Excessive vibrations/noise
No charging procedure possible Battery contacts contaminated Clean the battery contacts (e.g.
The charge control LEDs 18 and
19 respectively, do not light up
after inserting the mains plug
into the socket
F 016 L70 576 | (14.11.08)
Possible Cause
Height of cut too low
Cutting blade dull
Possible clogging
Blade fitted upside down
Height of cut too low
Grass too high
Grass wet or damp
Grass is dense
An additional battery can be
purchased from an authorised
customer service agent for
Bosch garden products
Cutting blade obstructed
Blade nut/bolt loose
Blade nut/bolt loose
Cutting blade damaged
The battery is defective, due to
a disconnection in the battery
(individual cells)
Mains plug of battery charger
not plugged in (properly)
Socket outlet, mains cable or
battery charger defective
Corrective Action
Increase height of cut (see "Ad-
justing the Cutting Height")
Replacing the blade (see
"Blade Maintenance")
Check underneath the machine
and clear out as necessary (al-
ways wear gardening gloves)
Refit blade correctly (see
"Blade Maintenance")
Increase height of cut and walk
slower
Increase height of cut and walk
slower
Wait until grass is dry and walk
slower
Increase height of cut, walk
slower and cut more frequently
Contact Service Agent
Switch off machine
Clear obstruction (always wear
gardening gloves)
Tighten blade nut/boltn
Tighten blade nut/boltn
Replacing the blade
by inserting and removing the
battery several times) or re-
place the battery
Replace the battery
Insert mains plug (fully) into
the socket outlet
Check the mains voltage and if
necessary, have the battery
charger checked by an author-
ized customer service station
for Bosch power tools
Bosch Power Tools