1 - Grill assembly (Fig 5-8)
• To fit the lower grill plate : put the plate at an angle, insert the plate into the two notches located in the
middle of the grill, then push the grill plate down to lock into position underneath the metal tabs located
either side of the appliance - Fig 5-6.
• When positioning the grill plate ensure the channel for collecting the juice is aligned with the space allo-
cated for placing the juice collection container - Fig 7.
• Fit the upper grill plate in the same way by holding the plate at an angle and inserting the upper plate
into the two notches located in the middle of the grill - Fig 8.
• Insert the juice collection container into position by fitting it below the juice collecting channel on
EN
the lower grill plate - Fig 7.
2 - Before use (Fig 9-10)
• Unwind the power cord completely and then position the power cord safely. Do not allow the power cord
to hang over the edge of the worktop. Always plug the appliance into an earthed socket.
3 - Using the grill
3.1 - For the grill function (Fig 11-15)
• Press the on/off button, the button light and the indicator light turns on and the appliance will start to
heat up - Fig 11.
• Set the thermostat – there are 3 cooking settings to choose from depending on the type of food to be
cooked - Fig 12.
• Allow the appliance to pre-heat for about 5 to 10 minutes. Pre-heating is complete when the indicator
light goes off - Fig 13.
• Using food tongs, carefully place the food to be cooked onto the lower grill plate - Fig 14.
• The space between the two grill plates can be adjusted between 0 cm to 3.5 cm, depending on the size
and thickness of the food to be cooked - Fig 15.
3.2 - For the barbecue function (Fig 16-23)
• Grasp the handle and open the grill, pull up firmly and then open the grill to the 180 degree position.
The appliance is now completely open to provide a larger cooking area - Fig 16-19.
• Using food tongs, carefully place the food over the two grill plates - Fig 20-23.
3.3 - For the oven function (Fig 24-32) (comfort version)
• Grasp the handle and open the grill, pull up firmly on the upper section of the grill. At the back of the ap-
pliance lift and position the support accessory over the back section of the lower grill plate and then close
the upper section of the grill. The appliance is now in the oven position - Fig 24-28.
• Carefully place the food onto the lower grill plate - Fig 32.
34