Sound Quality - JBL On Stage III Manual Del Usuario

troubleshooting your jbl On Stage III
Technical Specifications
Frequency Response:
70Hz – 20kHz
Power Consumption:
20W Maximum
Power Input:
12V/1.5A
JBL On Stage III Transducer:
(4) 1 Full range per channel
Dimensions:
Diameter – 7 1/2 (190mm)
||
Height – 2 (51mm)
||
System Weight:
1.12 lb (0.51kg)
Battery:
Size – AA
Type – Alkaline, NiMh
DO NOT MIX BATTERY TYPES.
DO NOT MIX CHARGED AND
PARTIALLY CHARGED BATTERIES.
BATTERIES WILL NOT RECHARGE
WHILE IN JBL ON STAGE III.
If you have any questions or need further assistance, please visit www.jbl.com.
These specifications are subject to change without notice.
Symptom
Sound Quality
No sound from the JBL
On Stage III speaker
system
Possible Problem
No power to the system
Power adapter plug is not
inserted correctly
No volume or low volume
Input source volume is low
Low or drained batteries
iPod is paused
iPod is paused (battery-only
mode)
6
Solution
Ensure that the power supply is connected to a live
power source and properly connected to the JBL On
Stage III. Note: When the JBL On Stage III is powered,
a green power LED on the JBL On Stage III should
light up.
Touch the volume "Up" (+) pad on the volume control
to unmute and/or increase the system volume level.
Note: Touching the volume "Down" (–) pad lowers
the system volume. Touching both the (+) and (–)
volume control pads at the same time will mute the
system.
Increase the volume level on the audio source device.
Replace the batteries.
Press the Play button on the iPod or remote control.
If the iPod is paused more than 10 minutes, press the
JBL On Stage III's Power button to turn the unit back
on.