Tru-Test EziWeigh6 Guia De Inicio Rapido página 2

Installation
Note:
Mount the indicator and secure the cables so they cannot be
damaged by stock.
1 Install load bars under the platform on a firm, level surface (see
Load Bar User Manual).
2 Mount the indicator bracket onto a flat surface (timber rails,
concrete) or pipe-work.
3 Remove the dust caps on the load bar connectors. Connect the
load bar cables to the indicator.
The indicator automatically calibrates with Tru-Test load bars.
4 If required, connect the indicator to the mains power using the
power/communication cable and the power adaptor.
Tip:
Connect the dust caps together to keep out dirt and moisture. Dust
caps should remain in place at all times when the indicator is not in use.
Parts of the indicator
Weighing animals
1 Press to turn on the indicator.
2 Move the animal onto the platform.
3 Enter the animal's VID using the alpha numeric keypad, or scan
the animal's EID tag using an EID reader.
4 Wait for the stable light to illuminate.
5 Press .
When the animal moves off the platform, the indicator
automatically returns to zero.
Notes:

Entering the animal's ID is optional.

The animal's VID or EID may be entered before the animal steps
onto the platform.

When inducting new animals, both the VID and EID can be
entered.

Duplicate IDs cannot be recorded within the same session. If the
same ID is recorded twice in a session, the indicator will overwrite
the old record with the most recent information.
Tips:

Ensure that the animal is fully on the platform before pressing

Ensure that the underside of the platform or crate is kept clear of
dirt and stones.
.