Removing The Refrigerator Doors - Samsung RF25HMEDBSR/AA Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

<RF25HM**>
2" (50 mm)
2" (50 mm)
125°
125°
(1430 mm)
(1430 mm)
32 3/4" (830 mm)
32 3/4" (830 mm)
4 2/8" (106 mm)
4 2/8" (106 mm)
1 6/8" (45 mm)
1 6/8" (45 mm)
Each measurement based on the design
dimension, so it may differ depending on
the measuring method.
CAUTION
When moving your refrigerator
To prevent fl oor damage, be sure the front
adjusting legs are in the up position (above the
fl oor).
Refer to 'Adjusting the doors' on page 14.
Flat-blade screw
Flat-blade screw
driver(-)
driver(-)
DA68-02952A-06.indb 10
DA68-02952A-06.indb 10
125°
125°
56 1/4" "
56 1/4
11 6/8"
11 6/8"
(300 mm)
(300 mm)
Control Lever
Control Lever
English - 10
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the fl oor. This surface
should be strong enough to support a fully loaded
refrigerator. To protect the fi nish of the fl ooring, cut
a large section of the cardboard carton and place
it under the refrigerator where you are working.
When moving a refrigerator, you need to pull and
push it straight forwards or back. Do not wiggle it
from side to side.
REMOVING THE
REFRIGERATOR DOORS
For some installations, you need to remove the
fridge doors and freezer drawer so you can
move the refrigerator to its fi nal location. Do not
remove the doors/drawers if you don't need
to. If you do not need to remove the refrigerator
doors or drawers, go to 'Adjusting the Level'
on page 14. If you need to remove the doors
and drawers. continue below. Before removing
the doors or drawers, make sure you read the
following warnings:
WARNING
Disconnect power to the refrigerator before
removing the door or drawer.
• Be careful not to drop, damage,
or scratch the doors/drawer while
removing them.
• Be careful not to injure yourself while removing
the doors/drawer.
• Reattach the doors/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
2015. 4. 23.
2015. 4. 23.
7:53
7:53

Publicidad

Tabla de contenido
loading

Tabla de contenido