Parallel Function Activation; Programming The Locomotive Address - LGB 55016 Manual De Instrucciones

Parallel Function Activation

Many LGB locomotives with a decoder onboard can re-
ceive commands for Locomotive Functions 1 – 8 directly
(or "parallel"). Others receive the function commands
"serially" one after the other from "1" commands
(example: "3" = "1+1+1"). Parallel data transmission is
of course faster, but it is not possible if all of the MTS
components are set at "p".
Press Buttons and
F
transmission on the Locomotive Hand Controller to
"parallel" for the locomotive in use. When you are using
several hand controllers, this must be set accordingly on
each hand controller. Press Buttons
change the locomotive in use back to "serial".
The setting "serial" or "parallel" remains stored for
each locomotive number in question, even when the
hand controller is turned off.
in order to change the data
9
and
F 9

Programming the Locomotive Address

You can program addresses 00 to 15 directly with the
55016 Handheld Locomotive Controller via the central
unit:
• Remove all other locomotives or items with a decoder
from the track.
• Hold the
down.
• At the same time briefly, press the Reset button on the
central unit.
• The display on the hand controller will show
• Release Button
again to
• Enter the locomotive number:
00 – 15 (on older central units 00 – 07)
• Brief jerking by the locomotive indicates that the
programming procedure was successful.
• Press the
button on the hand controller pressed
STOP
.
STOP
again in order to resume operation.
STOP
.
P - -
13