Analog Operation; Connections To The Analog Locomotive Controller; Operation With The 51070 Analog Locomotive Controller - LGB 55016 Manual De Instrucciones

Analog Operation, Operation with the Analog
Locomotive Controller

Connections to the Analog Locomotive Controller

Connections to the analog locomotive controller can
only be done using the 55050/55055 LGB radio remote
control. The 55050 RC Sender must be added to the
Handheld Locomotive Controller to do this.
Please pay attention to the operating instructions for
55050 for the installation and connections.
The battery holder in the hand controller is only for the
radio operation with LGB 55050/55055.
14

Operation with the 51070 Analog Locomotive Controller

Since several power circuits can be controlled with the
Locomotive Hand Controller, you must select the desired
power circuit after you have turned the controller on.
The power circuit selected is represented in the display
as (xx is the number for the power circuit). Press
L x x
Button in order to change the power circuit;
0
then appear on the display. Enter the number for the
desired power circuit as a two-digit number (01 – 08).
The newly selected power circuit is then shown on the
display.
will
L - -