LaserLiner StarFinder Manual De Instrucciones página 10

StarFinder
CAUTION: Wires which are at a depth of more than 4 cm
may not be detected. Always switch off the power supply
when working near electric wires.
Tip 1: Depending on surface material electro-static
interference may occur when moving unit, LED's will
light up. In this case move tool slowly over the wall
without touching surface.
Tip 2: Because of static charges, electric fields may be
detected at the side of the actual position of the wire.
To carry away these charges, lay your free hand on the
wall.
Tip 3: If you suspect that wires must be present but cannot
find any, this may be because they are shielded in
conduits. Use STUDSCAN in order to check the near
area.
Tip 4: The position where you start is important: To achieve
maximum sensitivity, start by placing the device in a
position which is known not to be near live wires.
Tip 5: With the Set Button (4) the sensivity can be adjusted.
The highest sensivity (max. 4 cm) can be found the the
mode "Super"-Deep.
Subject to technical alterations.
Warranty
The warranty is valid for 2 years from the date of purchase.
The warranty does not cover damage caused by improper use
or storage, normal wear and tear, or defects which only insi-
gnificantly impair the value of the product or its functioning.
Any tampering by unauthorised persons will render this war-
ranty void. In the event that you need to claim warranty, plea-
se take the complete device together with all information and
the invoice to one of our dealers or send it in to UMAREX-
Laserliner.
10
STUD-SCAN: Continuous current
monitoring in unshielded wires as soon
as an electrical field is detected.
ENGLISH