LaserLiner StarFinder Manual De Instrucciones página 8

StarFinder
• Select "Super-Deep" (SET button) for thick wooden panels
and floor constructions (parquet etc.), max. measuring
depth 6 cm.
• Place the tool against the wall.
• LED CAL (3) flashes: Press the calibration button (7) and
wait until calibration is completed. CAL OK: LED CAL (3)
lights permanently.
Slide the tool sideways across the wall.
When the maximum display appears, you
have reached the edge of the stud.
• Move the tool slowly across the surface.
IMPORTANT: The device must be in contact with the wall all
the time while measuring in StudScan-Mode. AC-Mode see
next page.
Tip 1: The position between the two markings is the mid-
point of the stud.
Tip 2: The position where you start is important: First place
the tool in a position where you know there is no stud.
Otherwise, the LED CAL (3) will blink. To verify: Move
the tool to another position a few centimetres away
and start measuring again.
Tip 3: The maximum display does not light up, even though
the LE display shows a reading. As soon as the most
intense display appears, the tool is over the edge of the
stud. Mark this point. Alternatively, increase the measu-
ring depth (SET button).
Tip 4: To avoid interference while scanning, keep your free
hand and other objects at least 15 cm away from the
StarFinder.
Tip 5: The StarFinder will only find the outside edge of double
studs and headers which may be fitted around doors,
windows and corners.
8 ENGLISH
Then scan for the
other edge of the
stud.