5 .
1
EN
Rinse water tank manually with fresh drinking
water. Fill water tank with fresh drinking water.
Insert water tank into machine.
4
Switch on machine. Power button starts
blinking red while machine is heating up for
approximately 40 seconds. Afterwards power
button lights steady green. Machine is ready
to use.
7
Continue rinsing with hot water: Set bar
display to maximum level with selector wheel.
Touch hot water icon. Machine starts rinsing.
Lights on bar display vanish progressively.
F I R ST U S E
2
Open locking handle. Make sure that rinsing
tool is in capsule holder and capsule holder
is in machine. Close locking handle. Place an
empty large container underneath the coffee
outlet.
5
Set bar display to maximum level with selector
wheel. Touch cold water icon. Machine starts
rinsing. Lights on bar display vanish progres-
sively.
8
Wait until countdown is finished and machine
stops. Open locking handle. Pull out capsule
holder. Remove rinsing tool. Reinsert capsule
holder.
3
Ensure to use the correct mains voltage as given
in "2. MACHINE OVERVIEW". Connect power
plug to mains power socket.
6
Wait until countdown is finished and machine
stops.
9
Empty container. Fill water tank with fresh
drinking water. Insert water tank into machine.
Place drip grid on drip tray. Then insert drip
tray at desired position.
8