English - Ryobi ROBOYAGI Guía De Resolución De Problemas

TROUBLESHOOTING
PROBLEM
I cannot turn on ROBOYAGI.
ROBOYAGI has a blank
display.
ROBOYAGI is not cutting,
and screen is blank.
ROBOYAGI is inside the
perimeter, but an error
indicates that the mower is
outside the boundary wire
loop.
ROBOYAGI is not working
correctly when installed next
to another robotic mower.
ROBOYAGI does not start
cutting.
ROBOYAGI is not docking.
ROBOYAGI is not
undocking.
ROBOYAGI shakes
sometimes before or after
turning.
ROBOYAGI is getting
stuck when encountering
certain obstacles, such as
trampolines, swings, trees
with exposed roots.
2

English

Original Instructions
POSSIBLE CAUSE
Incorrect setup procedure
Over-the-Air (OTA) update
failure
Incorrect starting of
product
Wire-to-charging station
connection method
Incorrect wire setup
Wire signal conflict
Battery / schedule
Improperly installed wire
Obstruction or friction
Bump sensor calibration
Boundary wire improper
setup
Follow the setup instructions, ensuring that the mower is
plugged into the powered dock before starting.
Perform OTA update using the ROBOYAGI app again.
Ensure that the battery is installed securely (listen for the
click).
If the issue persists, contact an authorised RYOBI service
centre.
the Always start or resume the mower after pressing the stop
button or if changes have been made to the settings.
Please refer to the Setup sheet or the "Installing the
charging station and boundary wire" section of the
manual.
If issue continues, switch the wire connections on the
charging station terminals (T1, T2).
Please ensure that there is a minimum space of 1.5 m
between boundary wires.
RYOBI cannot guarantee full compatibility between
ROBOYAGI and other nearby robotic mower installations,
or other wired systems (e.g. animal fencing).
Make sure that the battery is fully charged.
Please check your schedule settings (manual cut mode
should always work).
Make sure that the door is fully closed.
It is possible that ROBOYAGI may take a few attempts
to dock.
If ROBOYAGI is not docking, ensure that:
- Docking path is not obstructed.
- Charging socket is clean with no blockages.
- Charging pad is positioned on flat ground.
- Wire is threaded through the middle of the charging pad.
- Wire extends 1 m straight at 90° to the front of the
charging pad.
- Wire extends at least 30 cm at 90° to the rear of the
charging station
Please refer to the "Installing and connecting the charging
station" section of the manual.
Ensure that there are no obstructions preventing
ROBOYAGI from backing up out of the dock.
Ensure that the charging pad is positioned on a flat
ground.
This happens if the bump sensors do not automatically
return to their natural state. It is a normal auto-correctible
behaviour and requires no action.
If ROBOYAGI shakes all the time, contact an authorised
RYOBI service centre.
Route the boundary wire around the obstacles.
Please refer to the Setup sheet or the "Installing the
charging station and boundary wire" section of the
manual.
SOLUTION