Ryobi ROBOYAGI Guía De Resolución De Problemas página 5

Grass is cut unevenly.
ROBOYAGI is not charging.
ROBOYAGI has stopped
while on the lawn.
There are bare patches
or tracks appearing on my
lawn.
Some areas of my lawn are
not being cut often.
PIN code error
ROBOYAGI does not cut the
complete perimeter.
The selector knob has
stopped working.
There is a red light on LED
indicator of the charging
station.
There is a blue light on LED
indicator of the charging
station.
Damaged or worn out blades
Irregular cutting schedule
Charging port connection
problem
Battery is fully charged
Empty battery
Alert in mower
Running the mower for too
long
Mower settings
Incorrect PIN
Obstacles on the lawn
Hardware error
Charging station error
Perimeter loop error
Review the boundary layout, referring to the manual for
guidance.
Add up to 3 other variable start points to ensure that all
parts of the lawn are cut evenly and regularly.
You may need to extend the schedule to ensure regular
cutting of all areas.
Check and replace blades, referring to manual for
guidance.
Check the cutting height settings.
Ensure that the LED indicator of the charging station is
flashing green while ROBOYAGI is docked.
Ensure that the battery is installed securely (listen for the
click).
Turn the mains power to the charging station off and on,
and reboot the mower.
If issue persists, the battery may need to be replaced.
Contact an authorised RYOBI service centre.
Return the mower to the charging station to recharge the
battery. Reboot the mower.
The battery may be getting too hot. Run the mower in
cooler conditions.
If issue persists, the battery may need to be replaced.
Contact an authorised RYOBI service centre.
Give the lawn time to rest and regrow before cutting.
Review and reduce your cutting schedule if necessary.
Mowing regularly in wet conditions may accelerate visible
tracks.
Review the boundary wire layout, referring to the manual
for guidance.
Add up to 3 other variable start points to ensure that all
parts of the lawn are cut evenly and regularly.
Experiment with changing the exit angle range on your
mower settings.
If still not cutting regularly, you may need to move your
mower into the area manually from time to time to ensure
cutting.
Ensure that the correct PIN code is entered on the
security screen.
If the PIN code has been forgotten, contact an authorised
RYOBI service centre.
Ensure that no obstacles are blocking the perimeter path
(e.g. toys).
Always ensure that the charging station is not obstructed.
Please contact an authorised RYOBI service centre.
Turn mains power to the charging station off and on.
If issue persists, contact an authorised RYOBI service
centre.
Ensure that the wire is connected securely to the
terminals on the charging pad (T1,T2).
Ensure that the perimeter wire loop is closed.
Ensure that the boundary wires, terminals, or connectors
are not touching each other.
Turn the mains power to the charging station off and on.
Original Instructions
3
English