Publicidad
Idiomas disponibles
Idiomas disponibles
SIARR
06 - 105
PREPARATION
* Remove the central part of the bumper.
* Remover the bumper support.
ASSEMBLY
* Fasten the tow bar crosspiece on to the vehicle
(without tightening) using fastening kit W.
* Fasten the right and left arms (without tightening) using fastening
kits Y and Z (the 6mm thick back plate is located on the floor).
FINISHING
* Tighten all of the nuts, screws and bolts to the torques indicated below.
* Make a cut in the bumper as per the diagram opposite.
* Replace the bumper.
FASTENING KIT
4 off HM16x45 screws
X
4 off HM16 nuts
4 off DEC16 washers
2 off HM10x100 screws
2 off HM10 nuts
2 off DEC10 washers
Y
2 off 10/22 washers
2 off spacers dia. 12/17 lg.74mm
2 off back plates thick6mm
M16
AC8.8
19,5daNm
M12
M16
AC10.9
27,5daNm
M10
M12
AC8.8
8,1daNm
M10
ASSEMBLY INSTRUCTIONS
4 off HM8x40 screws
Z
4 off 8/27 washers
4 off DEC8 washers
2 off HM8x40 screws
W
2 off 8/27 washers
2 off DEC8 washers
TORQUES :
AC10.9 11,4daNm
M8
AC8.8
AC8.8
4,7daNm
M8
AC10.9
AC10.9
6,7daNm
FILE : BUREAU\NOTICEDEMONTAGE\SIARR\NDMWESTFALIA\NDM06105-G - FOLIO NDMANG
Type
Type
Approval No.
Tow bar for
FIAT
e11*94/20*00*3776
Doblo
NB : Electrical diagram inside our universal or custom wiring kits.
PLEASE NOTE : (to familiarise yourself with the operating charasteristics refer to the log)
2,3daNm
If this tow bar is fitted in accordance with our recommendations it will give a complete-
3,3daNm
ly satisfaction. We cannot accept any responsability in the event of changes to or
improper use of this item.
306324600001
Max. Total
Max. Total
Max. Verti-
Authori. Weight Towable Weight
cal load
2 100 kg
1 100 kg
Value
D
60 kg
7,08 kN
Publicidad
